How to String Weed Eater – An Easy Guide to Doing It Right

A weed eater is one of the most important garden tools that you can have at home. It will make it easy for you to maintain a well-manicured yard on your own. There is no need to rely on the expensive services of a professional gardener to perform basic tasks, such as getting rid of weeds.

However, while a weed eater can indeed prove to be a useful tool, to allow it to maintain its tip-top condition through the years, you need to pay attention to its proper care and maintenance. In this case, one that you need to learn is how to string a weed eater. It might seem like a complicated task at first, but in reality, this is one thing that you can easily accomplish.

The Need to Replace Strings of Your Weed Eater

Even if you have the best weed eater, this is in no way a guarantee that it will deliver optimal functionality through the years. At one point, the strings will experience wear and tear. Fortunately, this does not mean that you have to instantly purchase a new replacement. All that you need to do is to replace the strings. Lucky for you, it is a relatively easy and quick thing to do.

Replace Strings of Weed Eater

You might ask, why do I need to replace the strings of my weed eater? The strings do not only cut grass. They also get in contact with several hard objects, such as stone, concrete, and posts. This makes the spinning line wear down quicker. The harder objects make it weaker and the strings can break. Hence, the weed eater will no longer be able to function as needed.

Steps on How to String a Weed Eater

If you intend to string a weed eater on your own, assuming that you will be replacing the old strings, here are the simple steps that you have to follow. Keep in mind that the steps will differ based on the type of the weed eater that you have. The steps that we will mention below will be applicable in case you have a single-line trimmer:

  • Start by the preparation of the line. The width and length of the line will depend on the size of what you will replace. Avoid wasting your money by purchasing the wrong line. Most of the time, the string should be anywhere from .065 to .095 inches. The wrong size can make the engine wear out quicker, or worse, the weed eater will not work at all.
  • Take out the retaining cap from the head of the weed eater. The method of removal may be different depending on the type of the weed eater that you have. In most cases, you have to unscrew the head or press the tabs.
  • After removing the cap, look for the starter hole, which is usually located in the center. Locate the end of the string and pull it out of the spool. Take out any dust or debris that could have been stuck.
  • Wind the replacement string to the spool while following the arrow or direction marked in the spool. Do this with care to prevent the string from overlapping and tangling. Continue wrapping until you reach the end.
  • Now that you are done winding the string, place the spool back in the head of the string trimmer. Screw or snap it back in place to secure the spool. Secure it properly in its in its position. Otherwise, there is a risk of serious injury when the string becomes loose.

String Weed Eater


At the end of the day, the steps above are general instructions on how to string a weed eater. Nonetheless, there may be differences based on the equipment that you have. To be sure, it would be best to consult with the instructions from the manufacturer. Follow these steps to be sure about your safety and to guarantee the best functionality of the weed eater. You may also like the video below, that shows how to re-string a weed eater.

Leave a Reply